DIGITAL READOUT SYSTEM FOR A LATHE, MILL OR OTHER MACHINES. Canada to border plus how much to destination.ĪCTUAL PHOTOS ARE OF THE ITEM BEING OFFERED: THIS IS A USED TELEDYNE GURLEY PATHFINDER. We will ship this machine for 500.00 to continental US. Includes an operators manual and maintenance manual and master electrical print. This has the older heavy duty feed control from earlier units that works well. But winter is upon the rockies so we did not have time to paint. This machine does run well and is worth a good paint job. Included is a full top plate of holders and some 5C collets. This machine has many years of service left in it.
Cross slide works well and table indexes good. Machine does tighten up a little at the far right on the ways so has some wear but most of these machines have more. This machine has a SONY LH51 DRO coupled to s SONY DG205BP digital probe.0001 reading for the Z axis.
The stop dogs for the 3 speeds and the forward-reverse dog were repaired so it feels good when shifting. Machine runs smooth and speed shifts well. We installed new upper and lower spindle belt and tuned the drive with a tachometer. This is a later model chucker SN 4561 R that has the off-on pull control. HARDINGE HC chucker that we did a lot of work on. Travel of tailstock quill 7" Motors: Power of main motor 10HP. 1-5/8" 4 TPI Tailstock: Diameter of tailstock quill 3" Taper of tailstock quill center M.T. travel of top slide 5-18" 4-way tool post size 1" x 1" Longitudinal leadscrew dia.pitch Dia. 0.1- 7mm Diametral pitch threads 50 Kinds. more 0.01354"rev Metric threads 47 Kinds. swing in gap 29" 31" Effective length in gap 6" Width of bed 13-3/4" Headstock: Spindle Nose D1-8 Diameter of spindle thru bore 3-1/8" Taper of spindle center M.T. swing over bed 20" 22" Distance between centers 60" 80" 120" Max. Digital readout 3-Jaw chuck 4-Jaw chuck steady rest follow rest Coolant system Light Specifications YCL 20 Inch Swing YCL 22 Inch Swing Capacities: Max. Last one! 20" x 80" Birmingham YCL-2080 Lathe New 2006 with Digital readout and tooling.
0 kommentar(er)
